We build industrial foot warmers that are small, tough, and focused. Think of them as compact heat snipers—halogen infrared tubes that deliver direct, radiant warmth right where your operators need it. No point heating the whole room. Just the spot that matters. Here’s the thing about the specs: we keep the heater short—300mm—so it slips into tight corners and keeps the heat pinpointed. It runs on 400V, the kind of power industrial sites already have, which lets us pack a lot of heat into a small tube. That means it warms up fast and hits hard. The halogen tech inside keeps the filament steady by recycling it with halogen gas. The result? Longer tube life and consistent output, shift after shift. The quartz envelope can take the shock of rapid on-off cycling without cracking. And the R7s connector? It’s a simple, two-pin end-cap that wires up quickly and holds its alignment in mounting brackets. No fuss. On the plant floor, this setup slides right in as a drop-in heat source for foot warmers, control panels, and small process zones. The concentrated infrared heat cuts response time and keeps the work area comfortable—without pushing your HVAC into overdrive. But wait—high heat density means you need proper airflow and shielding. That keeps nearby components safe and touch temperatures comfortable. It’s powerful, focused heat, and it’s best when you plan for it.